Connect your pedal
StajNano talks to your pedal over Bluetooth Low Energy. The first connection takes less than a minute.
Before you start
- Switch the pedal on and keep it within a few metres of your phone or tablet.
- Turn Bluetooth on in your phone or tablet.
- The pedal can be connected to one device at a time. Disconnect all other connected devices first: other phones and tablets, and any other app that is connected to the pedal.
First connection
- Open StajNano. The first screen says Tap to search.
- Tap the card. StajNano looks for pedals nearby. Allow Bluetooth when your phone asks.
- Tap your pedal in the list. Every pedal has the same Bluetooth name, so each row shows its signal strength instead: a stronger number (closer to zero) normally means the nearer pedal.
- Wait a moment. The logo screen reads your presets and the pedal’s state, then the control page appears.
Connect by itself next time
With the pedal connected, open Options (the gear on the control page) and switch Auto-connect to On. StajNano remembers that pedal. From then on, whenever the app is in front, it starts searching by itself and connects to a remembered pedal half a second after it hears it, even when somebody else’s pedal is nearer. Nothing else is ever connected by itself.
- You can register several pedals. Each one has a row under Auto-connect with a DEL button to take it off the list.
- The search runs only while the app is in front, never in the background.
- A change takes effect from the next connection.
If something does not work
The pedal is not found
Check that the pedal is on and that no other device is connected to it. Wait a few seconds and search again: on iPhone and iPad the very first search after opening the app sometimes misses the pedal and the second one finds it. If several searches find nothing, put the pedal in its Bluetooth pairing mode for a moment and search again.
It connects, but the presets do not load
Close StajNano completely and open it again. If it keeps happening, switch the pedal off and on, and if that does not help, switch Bluetooth off and on in your phone or tablet.
I switched the pedal off and on
StajNano goes back to the first screen. Tap the card to search again, or, with Auto-connect on, simply wait: it searches by itself and connects when the pedal is back.
I want to use a Bluetooth foot pedal as well
Open Options, switch BT Pedal to On and pick your foot pedal on the page that opens. See the MIDI reference for what each message does.
Still stuck? Write to support.